Before operating the glazed tile machine equipment, it is necessary to check whether the connection is firm, whether the mounting bolts and nuts are tightened, and to lubricate the left and right chassis after power on to start the machine. Open for test run. Whether there is oil in the oil window, whether the movement of each part is coordinated, the mold can only be installed after everything is normal, the power must be cut off when installing the mold, the motor belt or large gear must be moved to index the table by hand, and the slide is raised To the highest position. It is best to use an object supported between the workbench and the bottom surface of the slide to prevent the non-slip seat from falling naturally, causing an accident.
Find the center in the first row and the last row of the glazed brick machine, then tighten the lock nuts on both sides, pull a straight line back and forth in the center of the middle wheel, and adjust the upper and lower clearance shafts, then you can adjust the machine along the straight line. First, adjust the height of the four corners of the front and back of the curved brick press from the large frame to the upper end of the shaft, and then adjust from the first row to the last row, find a line to straighten and check, regardless of whether the lower shaft is in a straight line Up, please adjust the left and right sides of the lower shaft to be horizontal. The debugging method of the pressing plate of the brick press is running, for example, the pressing plate runs to the right, pads in the left corner or falls in the lower right.
Post time: May-09-2020