First, the height of the four corners lined up in front and rear of the color steel roof roll forming machine is the same from the upper end of the big frame. Then, from the first row to the last row, find a straight line and check if the lower shaft is in a straight line and adjust the left and right sides of the lower shaft to be horizontal.
Second, find the center of the first row and the last row of the color steel tile machine, then tighten the locks on both sides, pull a straight line in front of and behind the center of the middle wheel, and adjust the gap between the upper and lower shafts. You can adjust the machine along the line.
Third, Debugging method for pressure deviation of color steel roof roll forming machine. If the board runs to the right, put the left corner (feeding rack) up, or fall right bottom, the upper shaft falls with the bottom shaft.
Post time: Dec-07-2018