Functions and Characteristics
1. Steel- welded construction, standard upper and lower dies,vibration to eliminate inner stress,hydraulic transmission system,foot pedal with emergency stop.with high strength and good rigidity.
2. Hydraulic top-drive, steadiness and reliability. Mechanical stop, steel torsion bar to maintain synchronization, with high precision.
3. Motorized-adjusting device for back gauge and ram’s stroke, DRO for back gauge and ram stroke.
4. Deflection compensation unit installed under the worktable.
5. Manual crowned lower die holder is adopted for the machine above 250 tons.
6. DRO to display the values of back gauge and ram stroke.
|
Sheet metal bending machine parameters |
||
|
1 |
Cutting &Hydraulic type |
Double guide pillar |
|
2 |
Hydraulic motor power |
3kw |
|
3 |
Hydraulic Pressure |
10-12MPa |
|
4 |
Voltage |
380V/3phase/50 HZ(or as your requirement) |
|
5 |
Cutting drive |
Decelerating motor+ Chain drive gear all by high-frequency |
|
6 |
Control System |
Panasonic PLC |
|
8 |
Bending degree |
0-90 |
|
9 |
Operating mode |
Button+ Mitsubishi |
|
10 |
Main Frame |
300mm/350mm H-Beam or 350mm |
|
11 |
Backboard Thickness |
17mm |
|
12 |
Feeding Material |
GI/PPGI/PPGL |
|
14 |
Feeding Thickness |
0.2-0.8mm |
|
15 |
Feeding Width |
1-4m |
|
16 |
Effective width |
1-4mm |
|
17 |
Productivity |
0-60times/min |
|
20 |
Roller material |
45# steel |
|
21 |
Cutter material |
Cr12 mould steel heat-treated hardness of HRC = 60-62 degrees |
|
22 |
Brand Square |
A3 35mm thick plate arch |
|
22 |
Cr-Plating Size |
0.05mm |
|
23 |
Overall Size |
4300*1200*2100mm |
|
24 |
Total Weight |
1.8T |
Machine photos
Sales service:
1. We provide technical support for the entire life of the machine.
2. If the buyer needs a technician to go abroad, we will arrange the technicians, but the buyer should bear all the expenses, including visas, round-trip tickets, etc.
